Skip to Content

autocad similar command

Alignment

Alignment Parameter can give dynamic blocks the function of alignment automatically, which can save the step of rotating the blocks.

1. Add a alignment parameter for a roughness symbol

Draw a roughness symbol in the Block Editor (BEDIT). Select the icon of the alignment parameter. Specify the location and the aligned orientation of the parameter following what the computer asked as shown in the picture below, the dotted line is the align orientation.

alignment - Add a alignment parameter for a roughness symbol

 

2. Test the dynamic block

Insert the roughness dynamic blocks, move the align grips, the symbol will align with the interface of the dimensions, as shown pin the picture below.

alignment - Test the dynamic block

 

gstarcad

gstarcad

gstarcad

gstarcad