Skip to Content

autocad similar command

Chain Action

If you want to realize a symmetric stretch without changing the keyway center and the length of smaller diameter shaft changes with the stretch at the same time, how can you realize that?

1. Add stretch for Step Shaft

Add stretch parameter and action for step shaft as the following picture shows. Thereinto, the bolded objects indicate the operation object of action.

chain action - add stretch

Because the follow-up operation will not stretch the step shaft by grips of this linear parameter, the grip's number of the linear parameter can be modified to "0".

 

2.Add linear parameter for keyways

Set the base point position of the line parameter as "Center" in order to realize the symmetric stretch function.

chain action - add linear parameter

 

3.Add the stretch rightwards action for the keyway

chain action  - add stretch

 

4.Realize chain action

Select the "Distance" linear parameter and modify the chain action of prosperity from "NO" to "Yes" as the following picture shows.

chain action - "Distance" linear parameter

 

Add the Stretch Leftwards action for keyway as the following picture shows. Special Note: Do elect "Distance" for the linear parameter to stretch leftwards the operation objects set. This is a necessary procedure of the chain operation.

chain action - Add the Stretch Leftwards

 

5.Test Dynamic Block

After dragging the left grip, not only the keyway will stretch bi-directionally and symmetrically but also the smaller diameter shaft of the step shaft will stretch automatically. This is a chain action.

chain action - Test Dynamic Block

The realization of a chain action has two important procedures: First, modify the property value of the parameter that need to happen as linkage and modify the property of "chain action" from "NO" to "YES". Second, elect the parameter of objects that are elected to linkage action to set.

 

gstarcad

gstarcad

gstarcad

gstarcad