Skip to Content

autocad similar command

DWGCHECK system variable

Function Description:

The DWGCHECK system variable is used to check whether there exists potential problem when opening drawings.

Type : Integer
Saved in : Registry
Initial :value 1
Range : 0,1,2,3

System Variable Value:

0 : if a drawing that you try to open has a potential problem, you are warned before the drawing is opened
1 : if a drawing that you try to open has a potential problem, or if it was saved by an application other than one based on RealDWG, you are warned before the drawing is opened
2 : if a drawing that you try to open has a potential problem, you are notified at the Command prompt
3 : if a drawing that you try to open has a potential problem, you are notified at the Command prompt. If the drawing has a potential problem and the drawing was saved by an application other than one based on             RealDWG, you are warned before the drawing is opened

gstarcad

gstarcad

gstarcad

gstarcad