Skip to Content

autocad similar command

LIMITS command

The LIMITS command is used to set up the boundaries of grid and control its display in current model or named layout.

Command Access:

Menu : Format > Drawing Limits
Command : LIMITS

Command Prompts:

Specify lower left corner or [ON/OFF] <0.0000, 0.0000>:
Specify upper right corner <420.0000, 297.0000>:
Regenerating model.

Relative Glossary:

Lower Left Corner:
Specify the lower left corner of grid limits.

On : Turn on the limits checking. In the ON mode, users could not input a point outside of limit. For points inside of grid could be checked.

OFF : Turn off the limits checking and keep the current value to be checked next time.

gstarcad

gstarcad

gstarcad

gstarcad