Skip to Content

autocad similar command

LOFTNORMALS system variable

Function Description:

The LOFTNORMALS system variable is used to control the normals of a lofted object when it passes through cross sections.

Type : Integer
Saved in : Drawing
Initial value : 6
Range : 0 ~ 6

If specified paths or guide curves, this system variable is ignored.

System Variable Value:

0 : ruled
1 : smooth fit
2 : start cross section
3 : end cross section
4 : start and end cross sections
5 : all cross sections
6 : use draft angle and magnitude

 

gstarcad

gstarcad

gstarcad

gstarcad