3DPOLY command

The 3DPOLY command is used to create 3D polylines.

Command

3DPOLY

Ribbon: Home > Draw > 3D Polyline

Menu:Draw > 3D Polyline

Command Prompts

Specify start point of polyline:
Specify endpoint of line or [Undo]:
Specify endpoint of line or [Undo]:
Specify endpoint of line or [Close/Undo]:
……
Specify endpoint of line or [Close/Undo]:

Function Description:

The 3D polyline is a sequence as a single object that combined by connected straight lines; those straight lines could in different plane, but could not contain arc segment.

Relative Glossary:

Endpoint : Draw a straight line from the start point to the specified point. It will not stop prompting until pressing ENTER.
Undo : Remove the last drawn straight line and redraw from the last point.
Close : Draw a line to close the 3D polyline from the end point to the start point and exit the command. To close 3D polyline, there must be at least two line segments.

Article ID: 1204
Created: April 7, 2017
Last Updated: June 30, 2021
Author: GstarCAD Malaysia

Online URL: https://www.gstarcad.com.my/knowledge/article/3dpoly-command-1204.html